I bought 2 pionner 6x9 and 2 6 1/2 for interior speakers.. these are the details..?

Details:


6%26quot;x9%26quot; 5-way car speakers (pair)


carbon graphite injection-molded polypropylene (IMPP) woofer with Aramid fiber and butyl rubber surround


1-1/8%26quot; PET cone tweeter


1/2%26quot; and 3/8%26quot; PET dome supertweeters


1-3/4%26quot; lightweight diaphragm balanced-dome midrange


power range: 2-80 watts RMS (460 watts peak power)


frequency response: 25-35,000 Hz


sensitivity: 93 dB








Details:


2-way car speakers for 6-1/2%26quot; and 6-3/4%26quot; locations (pair)


injection-molded polypropylene (IMPP) composite woofer cone with cloth surround


1-3/16%26quot; PEI film dome tweeter


power range: 2-30 watts RMS (180 watts peak power)


frequency response: 40-30,000 Hz


sensitivity: 90 dB


mounting tabs for use in 6-3/4%26quot; openings


top-mount depth: 1-11/16%26quot;





can some1 please tell me what kind of amp to put to it.. im also putting in 2 bullet tweeters
I bought 2 pionner 6x9 and 2 6 1/2 for interior speakers.. these are the details..?
A 350-400watt 4 way amp should be fine. Unless if you bought a new radio that has an amp in it then you just might only need a 200 watt 2 way amp for the 2 speakers then hook up the 6 by 9%26#039;s to your radio amp
I bought 2 pionner 6x9 and 2 6 1/2 for interior speakers.. these are the details..?
devon is a retard


the 6.5s should be powered by your cd player, so should the tweeters (with proper crossover)





this amp would work good with the 6x9 speakers:


http://www.onlinecarstereo.com/CarAudio/...
Reply:You have two wattage on the two set of speakers. For a amp you cannot go over the lowest rated speaker. Or you run the change of blowing the speakers at the low end.. You do the math., and times by 2. If they were the same you could do it by 4.


Less than a 1000 watts peck. A 350 or 400 amps.


If they were a like; peck at 2000 watts. A 1000 amp.